Alto-Shaam QC-40 Operations Instructions download pdf (Page 8)

PG. 6 #8402 QC-40 INSTALLATION & MAINTENANCE MANUAL

2.0 — Control Set-Up and Operation

MICROPROCESSOR CONTROL

The Alto-Shaam

® Quickchiller™ includes a

microprocessor control panel which utilizes a menu

screen to guide the operator through all operation

mode sequences.

™

  

  

  

  



QUICK CHILL A

HOLD FOOD B

DEFROST FOOD C

PRINT REPORT D

—

CHILLING or HOLDING

1. LOAD FOOD. IF A PRINTOUT IS REQUIRED OR

IF "AUTO-CHILLING" INSERT PRODUCT PROBES.

2. SELECT MODE OF OPERATION "A" OR "B" FROM

THE MENU, THEN FOLLOW PROMPTS.

DEFROSTING

1. REMOVE FOOD FROM UNIT.

2. SELECT MODE "C" FROM MENU, THEN

FOLLOW PROMPTS.

NOTES:

• THE UNIT WILL PERIODICALLY AUTO-DEFROST

WHILE HOLDING.

• REFER TO THE OPERATION MANUAL FOR MORE

DETAILED INFORMATION.

...................

.....................

...............

.................

MENU SCREEN

— MAIN MENU SHOWN

CONTROL KEYBOARD

QUICK REFERENCE OPERATION GUIDE

Fig. 2.1.3

2.3 START-UP TEST

2.3.1 With the chiller door closed, test the door

buzzer and door switch by entering the hold

cycle. Press "B" on the keyboard when the

Main Menu screen appears on the display.

The compressor will become audible. After a

period of 60 seconds, open the unit door. A

buzzer should sound and the display will

prompt the operator to close the door.

2.3.2 Close the door and allow the unit to operate

for approximately 10 minutes. Verify the

operating time with the timer which appears

in the upper right-hand corner of the Hold

Mode display screen. If the timer does not

indicate the correct amount of time, begin the

SET-UP procedure once again.

2.3.3 With the food probe(s) remaining in the

appropriate holder (no product) verify a

decrease of the temperatures appearing in the

display. The temperatures displayed should

start at the approximate room temperature and

decrease from that point. If any of the

temperatures displayed are above 120°F

(49°C), considerably above normal room

temperature, contact the Alto-Shaam Service

Department.

2.3.4 Following the 10 minute test operation period,

press "D" on the keyboard to exit the hold

mode. Open the unit door and make certain

the interior walls of the unit are cold.

2.4 SEQUENCE OF CONTROL OPERATION

2.4.1 Refer to Tables 2.4.1 and 2.4.2 for an overview

of control operations. For more information,

refer to booklet No. 265, Quickchiller Operation

Procedure Guidelines.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 28 29

Comments to this Manuals

No comments

Alto-Shaam QC-40 Operations Instructions Page 8

Comments to this Manuals

Related products and manuals for Small kitchen appliances Alto-Shaam QC-40