Alto-Shaam QC-50 Operations Instructions download pdf (Page 6)

1.5 RECEIPT AND UNPACKING

Upon receipt of the Alto-Shaam® Quickchiller, note

any crate markings for special instructions and

check for crate damage. IMMEDIATELY notify the

carrier if there appears to be damage to the

equipment. The chiller is shipped from the

factory, securely fastened to a single shipping

pallet and protected by an external wrapping.

Carefully remove all external wrappings and other

protective coverings. If all is in order, discard

crating materials.

1.6 INSTALLATION

Prior to moving the Quickchiller to the installation

site, check the dimensions of doors, passageways,

and ceiling heights in the areas through which the

cabinet must be moved. Also check the turning

radius if the cabinet must be moved around an

existing structure.

Note: In certain instances, it may be necessary to

remove doors and door hardware to

negotiate tight spaces.

1.6.1 SITE SELECTION: Position the Quickchiller to

allow sufficient air ventilation through the

condensing unit(s). Rear of unit should be no

closer than 6" to any wall or structure.

Avoid installing the chiller immediately

adjacent to fryers, charbroilers, or any other

equipment producing grease laden air; heat

producing equipment such as ovens and

ranges; and steam discharging equipment such

as steamer ovens and kettles.

Allow sufficient front clearance for serviceability

and for easy maneuvering of food trolleys in and

out of the cabinet.

1.6.2. INSTALLATION REQUIREMENTS: Install the

Quickchiller on smooth and level floor surface.

Use the adjustable cabinet legs to level the unit.

Adjust from front-to-back and from side-to-side

to evenly distribute the cabinet weight and

avoid pulling the cabinet alignment out of

square.

After leveling the cabinet, check the height

relationship of the roll-in cart to the cabinet.

Adjust Quickchiller height as needed.

1.6.3 DOOR SEAL: Check the door gasket to make

certain it is sealing properly and that the

gasket provides an even and positive seal

around the entire door frame.

1.6.4 DRAIN HOSE: A single drain hose and floor

drain are required.

1.6.5 REMOTE CONDENSING UNIT GUIDELINES

Installation must be performed by certified

and authorized refrigeration service personnel

or warranty is void.

Interconnecting liquid and suction line sizes for

Quickchillers are as follows:

Separation distance between the Quickchiller and

condensing units must not exceed fifty (50) feet

with zero (0) lift. Liquid line lift (Quickchiller

elevation above that of condensing unit) reduces

allowable separation distance significantly.

Satisfactory refrigerating capacity is possible with

condenser entering air temperatures below 115°F.

Insulate both suction and liquid lines.

Suction lines should be pitched down 1/2" in 10' of

run in the direction of flow. A "P" trap (closely)

connected) is required for vertical risers greater

than 3 feet in elevation.

#8400 Installation & Maintenance Manual - Pg. 4

1.0 — General Information and Installation

9 "

(229mm)

8-3/4 "

(222mm)

3/4 " (19mm)

DRAIN

FIG. 1.6.4 PLUMBING: MODEL QC-50

Quickchiller Condensing Liquid Line Suction Line

Model

Unit Size Size

QC-40R Both 1/4" 3/8"

QC-50R Large 3/8" 7/8"

Small 3/8" 5/8"

QC-100R Both 3/8" 7/8"

1 2 3 4 5 6 7 8 9 10 11 ... 28 29

Comments to this Manuals

No comments

Alto-Shaam QC-50 Operations Instructions Page 6

Comments to this Manuals

Related products and manuals for Small kitchen appliances Alto-Shaam QC-50