Alto-Shaam QC-40 Service Manual download pdf (Page 33)

10•10 MARINE COMBITHERM ELECTRIC INSTALLATION AND MAINTENANCE MANUAL

PG. 31

EMERGENCY OPERATION

In the event of an error code, operation of the Combitherm can be continued on a limited basis for a short

duration. Cooking times may be longer than normal operation and close monitoring of the cooking

process is recommended. Contact an authorized service agency immediately if the problem cannot be

rectified with simple steps in the troubleshooting guidelines located in this manual. Error conditions

under which continued operation can be conducted are indicated by

YES in the chart shown below.

When the oven malfunctions, an error code will appear in the display.

PRESS THE START/STOP KEY TO ACKNOWLEDGE THE ERROR.

The keys for the usable operational modes will begin to flash and can be operated normally.

SELECT AND PRESS ONE OF THE COOKING MODES INDICATED.

The oven control will only respond to the oven mode keys flashing.

SET THE OVEN CONTROLS AS IF OPERATING UNDER NORMAL CIRCUMSTANCES.

Depending on the error code involved, oven function, such as temperature range, may be limited.

PRESS THE START/STOP KEY TO BEGIN THE COOKING PROCESS.

PRESS THE START/STOP KEY WHEN THE TIMER EXPIRES.

WHEN THE OVEN FAULT IS CORRECTED, THE COMBITHERM WILL RETURN TO NORMAL OPERATION.

Cooking time increases significantly. Food on the upper shelves is finished first.

Water injection into the condenser is activated for the entire cooking mode (high water consumption).

When error codes E23 and E26 appear simultaneously, steam generator does not preheat.

ERROR DISPLAY MESSAGE GAS ELECTRIC STEAM

SUPERHEATED CONVECTION RETHERM DELTA-T

CODE MODE STEAM MODE MODE MODE MODE

E01 Low water level YES YES NO NO up to 356°F NO YES

(180°C)

E02 EL-temperature too high YES YES YES Up to 284°F Up to 284°F Up to 284°F Up to 284°F

CONTROL COMPARTMENT TEMP (140°C) (140°C) (140°C) (140°C)

E03 Fan Fault NO YES Up to 212°FNO NONONO

BLOWER FAN (100°C)

E04 EL-fan fault NO YES YES Up to 284°F Up to 284°F Up to 284°F Up to 284°F

CONTROL COOLING FAN (140°C) (140°C) (140°C) (140°C)

E05 Gas fault YES NO YES YES YES YES YES

E15 Condenser oven temperature YES YES NO NO Up to 356°F NO YES

HIGH CONDENSATE TANK TEMP (180°C)

E21 Oven probe error NO YES 212°F only NO NO NO NO

TEMPERATURE PROBE (100°C)

E22 CTC error TEMPERATURE PROBE YES YES YES YES YES YES YES

E23 SG-probe error YES YES YES YES YES YES YES

STEAM GENERATOR PROBE B4

E24 Bypass probe error NO YES Up to 210°F NO YES NO YES

(99°C)

E25 Condenser probe error NO YES YES

Up to 356°F

YES

B3 PROBE (180°C) (180°C) (180°C)

E26 SG probe error NO YES YES YES YES YES YES

STEAM GENERATOR PROBE

E23 & SG probe error

NO YES YES

YES

NO YES

E26 STEAM GENERATOR PROBE B4

E33 SG heat error NO YES YES YES YES YES YES

STEAM GENERATOR ELEMENT

E34 Steam Generator pump error NO YES YES YES YES YES YES

E81 Program memory error YES YES YES YES YES YES YES

E83 Algorithm error YES YES YES YES YES YES YES

E89 12C error YES YES YES YES YES YES YES

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 44 45

Comments to this Manuals

No comments

Alto-Shaam QC-40 Service Manual Page 33

Comments to this Manuals

Related products and manuals for Small kitchen appliances Alto-Shaam QC-40