PROGR AMMIN G THE CONTRO L
5. Choose the correct melt cycle for your frying compound. The melt cycle will appear in the L E D as
“C Y L” or “CY S ”. “C Y L” is for liquid frying compounds such as oil and “ CY S ” is for solid frying
compounds such as shortening. Do not choose “ C Y 0” .
• Scroll to change melt cycles by pressing or .
• Press TWICE to accept the new setting and proceed to the lock.
NOTE: Do not press just once and change the “g A S” or “ E LEC ” setting.
6. Lock or unlock the Control Programming. “LoC ” or “U L o C” will appear in the L ED display.
“L o C” will prohibit unqualified personnel (without the password) from entering Control
Programming. “UL o C” will leave Control Programming locked.
• Scroll to change lock condition by pressing or .
• Press to accept the new setting and proceed to select °F or °C.
7. Select °F or °C for the temperature display. “F” or “ C” will appear in the L ED display. “F ”
will cause the L ED to display Fahrenheit. “C” will cause the LED to display Celsius.
• Scroll to change from °F to °C by pressing or .
• Press to accept the new setting and proceed to restart Control Programming sequence or press
and hold for one second to exit Control Programming.
NOTE: At any point in the sequence, pressing and holding for one second will exit Control
Programming.
B A S I C C O N T R O L O P E R A T I O N
Ga s Fr y er Op e r a ti o n & Ca r e M a n u al • 3 0
C A U T I O N
THIS SECTION IS PROVIDED FOR THE ASSISTANCE
OF QUALIFIED PERSONNEL ONLY AND IS NOT
INTENDED FOR USE BY UNTRAINED OR
U
NAUTHORIZED PERSONNEL.
Comments to this Manuals